推荐同事 机构合作 中文 繁體中文 English 한국어 日本語 Português Español

美国ACCDON公司旗下品牌

021-33361733，021-33632861

chinasupport@letpub.com

登录 注册 新注册优惠

Analysis of Numerical Simulation and Experimental of the Flange in the Deep Drawing of Box-Shaped Parts

K Chen, CY Peng… - Advanced Materials Research, 2011 - Trans Tech Publ
... of materials is serious, so the hardness test results are consistent with the results of theoretical
analysis and numerical simulation. To some extent, reflect the accuracy of the numerical simulation,
that is, strain capacity of rounded corners is greater than the straight edge, and the ...
Related articles

The Shear Strength of Dental Porcelain-A Laboratory Study

[PDF] from typographicsplus.comPM Kumar, S Varalakshmi… - Journal of the Indian …, 2011 - typographicsplus.com
... RESULTS Generally, the straight edge gave higher values, probably because it is less subject
to variations in the roundness of the specimens. ... The higher shear strength value obtained with
the aluminous porcelain was statistically significant at the 0.05 level using a t-test. ...

Analysis of Primary Aluminum Composite Panel Gypsum Board Construction Method Paste

XR Zhang, L Li - Advanced Materials Research, 2011 - Trans Tech Publ
... Not straight edge of the test: the board flat on the level of the stage, with specification
1000mm steel ruler on the side close to the edge, tape measure and then plug the edge
of the plate and steel ruler of the largest gap accurate to 0.1mm. ...
Related articles

Performance Criterion for Thin-Surface Low-Volume Roads

UC Sahoo… - Transportation Research Record: Journal …, 2011 - Trans Res Board
... Rut depth was measured with a 1.5-m-long straightedge. ... Longitudinal depression is the depression
measured under the straight- edge held along the wheelpath at the same location where rutting
was measured. ... TABLE 2 Details of Pavement Test Sections Subgrade Properties ...

Experimental Investigations and Analysis of Springback Based on Multi-Angle Panel Draw-Bending

JX Chen, X Zhang, CT Wang… - Advanced Materials …, 2011 - Trans Tech Publ
... 1 2 3 4 5 1 2 3 4 5 （1）test part 1 （2）test part 2 1 2 3 4 5 6 （3）test part 3 Figure1 Parts of
multi-angle straight edge Due to studying springback of the external covering on the body in this
experiment, the thickness is selected 1.0 mm; the cold-rolled low carbon steel and high ...

联系我们 | 站点地图 | 友情链接 | 授权代理商 | 加入我们

© 2010-2024 中国: LetPub上海分公司    网站备案号：沪ICP备10217908号-1    沪公网安备号：31010402006960

增值电信业务经营许可证：沪B2-20211595

礼翰商务信息咨询（上海）有限公司      办公地址：上海市徐汇区漕溪北路88号圣爱大厦1803室

United States: Tel: 1-781-202-9968 Address: 400 5th Ave, Suite 530, Waltham, Massachusetts 02451